Welcome to my blog

Today I cut a slot in the axle with an angle grinder for the keyway slot. I then welded the sprocket onto the hub and slid it onto the axle. I then put the cv joint back together and put it on the car. After…

Got a few odds and ends done today. Main big thing was to get the electric motor mount made up. I didn’t get time to finish bolting it up but that will be next. Once the motor is mounted then I just need to take…

My plasma cutter decided to die today so it took me forever to cut out the mounting brackets for the motor. I managed to get the plate the motor attaches to made up and one side of the bracket made. It doesn’t look as good…

I tried using a set of front springs on the back but it didn’t give me enough extra to get the car sitting level again. I looked around and the only other springs I had available easily were the front springs off a 93 Ford…