Forming a wing

I started trying to build a wing for the trunk lid. I am using foam and shaping it to get the look I am after. Then I will make it out of fiberglass and mount it to the car. It will fix one of the big problems with the trunk and hopefully look nicer.

Trunk Lid Bolted Down

Didn’t get much time to work on the car today but I did manage to get the trunk lid bolted down solidly.

Aligning the trunk lid

I unbolted the trunk lid from the car and hung it from the ceiling with straps to position it on the car. The trunk has is warped and will not sit flat on the car. It took a bit of measuring to figure out how it is twisted but after getting it sorted out I […]

Finished Dropped Spindles and Heater Box

Got a bunch of small things done today. First thing was finish the drivers side dropped spindle. After that I dropped it down on the ground and got a picture of how it sits.

Installing Dropped Spindles

I should be getting some time to start back on this car. All the structural parts are mostly in place so I think it is time to start putting some things together for the last time. The easiest thing to do is the front end so that is what I am going to work on […]

Wiper Assembly Installed

After a short break from working on the car I am back on it at least occasionally. One of the last fitment problems is getting the wipers and heater box to fit in the car and still have room to fit the passenger’s foot area. I tried using the stock Metro wiper assembly and it […]

Pedals remounted and starting on wipers

Today I worked on mounting everything under the dash. First was put the pedals back in then remove all the old stuff from the car. It took a while to get the pedals in place and get the steering wheel at the right height to be comfortable driving. But after it was in I checked […]

Firewall and pedal mounting started.

Today I started by framing up the front section of the floor. I will make the floor later. I mostly wanted it framed in so I could start building the firewall and getting everything mounted. With the floor lowered an inch and the body raised 3/4 off the frame I have more room for the […]

Back half of the floor area built

I decided to split the floor into two parts. The back part will be welded in and the seats and seat belt hardware will be mounted solidly on it. The front half will be bolted on so I can remove it to access under the dashboard. I just had to cut and weld on some […]

Starting on the floor

I got the body lined back up on the car so now it is time to start fitting the interior of the car together. First thing is to get the seat area finished so I can sit in the car and test fit the locations of all the dashboard parts. I need a bit more […]