Today was a slow day with what seems like not much progress. I first cut out 4 plates to go on either side of the fiberglass to reinforce the hinge area. I bolted them through the fiberglass and drilled the large hinge bolt hole once…
The rear toe bars were fairly easy to build. I took the tie rods off the front end and used a bolt to mount the inner rod solidly. I tried to keep the same geometry as the stock front end but since it is mostly…
Today I built the strut towers. I tried to come up with a way to do it without using a brace across the top but it would be much heavier than just a bolt on brace. So I will make a bolt on brace to…
I ended up digging up a bunch of parts to try and come up with something for the transmission mount that would still be strong. I ended up cutting the stock mount in half and bolting a rear transmission mount to the bracket. Then I…
Didn’t have a lot of time to work on the car but I managed to get it on the ground, get the trunk lid off, and get the motor and transmission located properly. After that I made the motor mount and rear mount. I still…