Posted on May 26th, 2016 by Rick Thompson
I need to get the layout on where everything goes figured out. So before I start making the flange for the trunk lid to seal against I need to come up with how the rest of the stuff is going to fit. The first thing is the wall for the storage area. I used plastic […]
Filed under: Uncategorized | Comments Off on Working on cargo area layout
Posted on May 25th, 2016 by Rick Thompson
With the trunk lid cut free and the back of the car mounted I need to get it all squared up good before I can build inner fenders and stuff. I tried a few different things to get everything to sit square and finally came up with a way to get it all lined up. […]
Filed under: Uncategorized | Comments Off on Start of framing up trunk and rear fenders
Posted on May 17th, 2016 by Rick Thompson
I worked out how to attach the hinges to the roll bar. It was hard to get them lined up and attached. I ended up bolting a plate onto the hinges and welding the plates on to the roll bar after I got it lined up right. After getting it welded in place and making […]
Filed under: Uncategorized | Comments Off on Trunk Hinges
Posted on May 4th, 2016 by Rick Thompson
Managed to get the trunk lid cut apart today. It didn’t take long to get it apart and the lower section bolted down solidly. After checking it for square it seems to sit on the frame pretty well. I will probably end up making new inner fenders and seal off the whole back area to […]
Filed under: Uncategorized | Comments Off on Trunk Lid Cut Out