Posted on March 25th, 2016 by Rick Thompson
I started trying to build a wing for the trunk lid. I am using foam and shaping it to get the look I am after. Then I will make it out of fiberglass and mount it to the car. It will fix one of the big problems with the trunk and hopefully look nicer.
Filed under: Uncategorized | Comments Off on Forming a wing
Posted on March 23rd, 2016 by Rick Thompson
Didn’t get much time to work on the car today but I did manage to get the trunk lid bolted down solidly.
Filed under: Uncategorized | Comments Off on Trunk Lid Bolted Down
Posted on March 21st, 2016 by Rick Thompson
I unbolted the trunk lid from the car and hung it from the ceiling with straps to position it on the car. The trunk has is warped and will not sit flat on the car. It took a bit of measuring to figure out how it is twisted but after getting it sorted out I […]
Filed under: Uncategorized | Comments Off on Aligning the trunk lid
Posted on March 20th, 2016 by Rick Thompson
Got a bunch of small things done today. First thing was finish the drivers side dropped spindle. After that I dropped it down on the ground and got a picture of how it sits.
Filed under: Uncategorized | Comments Off on Finished Dropped Spindles and Heater Box
Posted on March 19th, 2016 by Rick Thompson
I should be getting some time to start back on this car. All the structural parts are mostly in place so I think it is time to start putting some things together for the last time. The easiest thing to do is the front end so that is what I am going to work on […]
Filed under: Uncategorized | Comments Off on Installing Dropped Spindles