Gas tank, floor, and radiator installed

Today I worked on getting a few things mounted. I first made a few brackets to mount the gas tank in place. I had to raise it an inch and a half off the frame to clear the shifter rods. It will also need the extra clearance later for the parking brake cables. The tank […]

Shifter installed

Got a working shifter setup installed in the car today. Since the front wheel drive setup had a shift rod running straight out the back it was not that hard to bend a section of pipe to go around the frame and run it forward instead. It works good the way it is. I need […]

CV axles installed

I managed to get the CV axles made up and installed today. I ended up using two axles on one side. I just stuck them both in one in the engine and one in the wheel then marked them in the center to know where to cut them both off at. I then used a […]

Gas tank finished

Didn’t get a lot of time to work on it today but I at least managed to finish mounting the fuel pump and get it wired up and everything on it working properly.  With the tank assembled I figured I might as well check the clearance on it to see what kind of room I […]

Steering installed and started on gas tank

The steering parts came in today so I put it all together. The stock rack was not long enough so I put a set of rack extenders on it to make it the proper angle so there is no bump steer. The front end is basically done except for letting the front arms settle then […]